|
| Adjustable Air Liquid Atomising Nozzle |
|
The Adjustable air atomising assemblies combines air and liquid by knob adjustment. By changing the spray tip setup, different spray pattern such as full cone, hollow cone and fan can be attained without changing the body assembly. Material : 316 stainless steel or brass. Size :1/4"NPT(F) air & liquid inlets |
|
With independent stream and control of Air and liquid
inlet, the Air / Liquid Atomising Fan Spray External mix
facilitates fine atomisation for liquid that contains abrasive
suspended particles and is well suited even for viscosity above 150 centipose. Spray Angle : 45 or 60 degrees Fan DOWNLOAD CAT - SUE_Air_Atomising.pdf
|
.jpg)
|
The liquid and air stream
being dependent on each
other, collide under
pressure in the internal
mixing chamber effecting a
thorough mix before exiting
the orifice. The Internal
mix produces the finest
atomisation possible in any
Air and liquid atomiser.
However, it is gets clog
easily for liquid with
viscosity above 150
centipoise. Spray Angle : Wide angle 60 degrees to 70 degrees Cone DOWNLOAD CAT - SUK Air Atomising.pdf
|
| Gas Cooling Nozzle - Critical Mass Flow Atomising |
|
The device where the liquid flow
and the airflow come into
contact with each other to
produce a volumetric fine mist
spray use for gas cooling
applications. The two stream of
liquid and air collide and exit
the spray cap at high velocity
spray discharge to effect fine
atomisation.
A
spray set-up is configured for 30
degree, 90 degrees and 120 degrees.
When assembled, the air nozzle fits
precisely onto the liquid nozzle and
the combination of the two provides
the required geometry to originate
the spray.
Download Catalogue : SA_1.pdf |
| Liquid Atomising |
|
RII series
Atomising nozzle with
ruby Insert orifice for high velocity
spray discharge to effect fine atomisation.
Spray
angle for 30
degree. Material : stainless steel
c/w filter
Size : 1/4 inch Male NPT
|
Tel: +65 67741828 (Sales Hot-Line) Fax: +65 67779813 E-mail: sales@wilsonspraynozzle.sg